資料紹介
3-071-929-04 (1)
© 2001 Sony Corporation Printed in Japan
RM-DR1
Remote Commander
Operating Instructions
Mode d’emploi
Bedienungsanleitung
Manual de instrucciones
Gebruiksaanwijzing
Bruksanvisning
Istruzioni per l’uso
Manual de instruções
Инструкция по эксплуатации
ACC
A
B
C
D
E
English
THIS CLASS B DIGITAL DEVICE COMPLIES WITH PART
15 OF THE FCC RULES AND THE CANADIAN ICES-003,
OPERATION IS SUBJECT TO THE FOLLOWING TWO
CONDITIONS : (1) THIS DEVICE MAY NOT CAUSE
HARMFUL INTERFERENCE, AND (2) THI
All rights reserved.
資料の原本内容
3-071-929-04 (1)
Remote Commander
This product has been tested and found compliant with
the limits sets out on the EMC Directive for using
connection cables shorter than 3 meters.
The RM-DR1 Remote Commander is designed to operate
a Sony digital still camera equipped with an ACC
terminal. You can operate the camera remotely.
Notes
Operating Instructions
Mode d’emploi
Bedienungsanleitung
Manual de instrucciones
Gebruiksaanwijzing
Bruksanvisning
Istruzioni per l’uso
Manual de instruções
Инструкция по эксплуатации
使用說明書
사용설명서
使用说明书
• Be sure not to drop the Remote Commander or spill
liquid on it.
• Do not leave the Remote Commander under direct
sunlight, near a heater or in locations with high humidity.
• When you turn the Remote Commander off, wait a while
before turning it on again. Operating the POWER switch D
repeatedly may damage it, and the Remote Commander
may not turn on properly.
• When inserting or pulling the remote cord E out of the
ACC terminal of the Digital Still Camera, be sure to do so
in a straight line. Performing this operation incorrectly
may damage either the remote cord or the camera.
Identifying the parts
A Shutter button
B Zoom lever
C POWER lamp
D POWER switch
E Remote cord
Preparing the Digital Still Camera
RM-DR1
Set the camera to record images. Refer to the operation
manual of the digital still camera for further information.
Connecting to the Digital Still Camera
© 2001 Sony Corporation Printed in Japan
Connect the remote cord E of the Remote Commander to
the ACC terminal of the Digital Still Camera.
Using the Remote Commander to record
1 Slide the POWER switch D down along the arrow mark to
turn on the camera. The POWER lamp C turns green light.
2 Press the shutter button A lightly to check the image.
The image is not recorded yet.
3 Press the shutter button A fully down. The image is
recorded.
4 Slide the POWER switch D down along the arrow mark
to turn off the camera. The POWER lamp C turns off.
A
B
C
D
ACC
E
Using the zoom feature
Slide the zoom lever B to either the W or T side. Sliding
slowly zooms slowly and sliding faster zooms fast.
T side (for telephoto): subject appears closer.
W side (for wide-angle): subject appears farther away.
* Some models do not have the zoom function.
Using the strap
When using a tripod, you can hang the Remote Commander
on the pan handle of the tripod when you are not using it.
Specifications
Dimensions: 35 × 89 × 23 mm
(1 7/16 × 3 5/8 × 29/32 inches) (w/h/d)
Remote cord: 1.5 m (4.9 feet)
Mass:
Approx. 60 g (2 oz)
Accessories: Operating Instructions (1)/Strap (1)/Pouch (1)
Refer to the operation manual of the digital still camera
for further information as well.
Français
THIS CLASS B DIGITAL DEVICE COMPLIES WITH PART
15 OF THE FCC RULES AND THE CANADIAN ICES-003,
OPERATION IS SUBJECT TO THE FOLLOWING TWO
CONDITIONS : (1) THIS DEVICE MAY NOT CAUSE
HARMFUL INTERFERENCE, AND (2) THIS DEVICE
MUST ACCEPT ANY INTERFERENCE RECEIVED,
INCLUDING INTERFERENCE THAT MAY CAUSE
UNDESIRED OPERATION.
CET APPAREIL NUMÉRIQUE DE LA CLASSE B EST
CONFORME À LA NORME NMB-003 DU CANADA.
Ce produit a été testé et déclaré conforme aux limites définies
dans la directive CEM concernant l’utilisation de câbles de
connexion dont la longueur est inférieure à 3 mètres.
La télécommande RM-DR1 est conçue pour commander un
appareil photo numérique Sony équipé d’une borne ACC. Vous
pouvez ainsi faire fonctionner l’appareil photo à distance.
Remarques
English
THIS CLASS B DIGITAL DEVICE COMPLIES WITH PART
15 OF THE FCC RULES AND THE CANADIAN ICES-003,
OPERATION IS SUBJECT TO THE FOLLOWING TWO
CONDITIONS : (1) THIS DEVICE MAY NOT CAUSE
HARMFUL INTERFERENCE, AND (2) THIS DEVICE
MUST ACCEPT ANY INTERFERENCE RECEIVED,
INCLUDING INTERFERENCE THAT MAY CAUSE
UNDESIRED OPERATION.
CET APPAREIL NUMÉRIQUE DE LA CLASSE B EST
CONFORME À LA NORME NMB-003 DU CANADA.
For the Customers in USA
Caution
You are cautioned that any changes or modifications not
expressly approved in this manual cou...
